Ruijie RG-S2900G-E Series - Page 132

Configuration Guide EEE Configuration
ID
Port trouble cause
Description
0
None
Normal
1
Link Down
An interface link goes down.
2
Speed Not Supported EEE
A port in speed mode does not support EEE.
4
Auto-Negotiation Was Off
A port is disabled with auto-negotiation.
5
Remote Disable
A peer port is disabled with or does not support EEE.
To display EEE statuses of all ports, run the show eee interfaces status command without specifying a port ID.
The following example displays EEE statuses of all ports.
ruijie#show eee int st
Interface EEE Admin Oper Remote Trouble
Support Status Status Status Cause
----------------------------------------------------------------
Gi0/1 Yes Enable Disable Unknown 1
Gi0/2 Yes Enable Disable Unknown 1
Gi0/3 Yes Enable Enable Enable 0
Gi0/4 Yes Enable Enable Enable 0
Gi0/5 Yes Enable Enable Enable 0
Gi0/6 Yes Enable Enable Enable 0
Gi0/7 Yes Enable Enable Enable 0
Gi0/8 Yes Enable Enable Enable 0
Gi0/9 Yes Enable Enable Enable 0
Gi0/10 Yes Enable Enable Enable 0
Gi0/11 Yes Enable Enable Enable 0
Gi0/12 Yes Enable Enable Enable 0
Gi0/13 Yes Enable Enable Enable 0
Gi0/14 Yes Enable Enable Enable 0
Gi0/15 Yes Enable Enable Enable 0
Gi0/16 Yes Enable Enable Enable 0
Gi0/17 Yes Enable Enable Enable 0
Gi0/18 Yes Enable Enable Enable 0
Gi0/19 Yes Enable Enable Enable 0
Gi0/20 Yes Enable Enable Enable 0
Gi0/21 Yes Enable Enable Enable 0
Gi0/22 Yes Enable Enable Enable 0
Gi0/23 Yes Enable Enable Enable 0
Gi0/24 Yes Enable Enable Enable 0
Gi0/25 No - - - -
Gi0/26 No - - - -
Gi0/27 No - - - -
Gi0/28 No - - - -