Ruijie RG-S2900G-E Series - Page 156

Configuration Guide Interface Configuration
Ruijie# show interfaces gigabitethernet 1/2 description
Interface Status Administrative Description
-------------------- --------- --------------- ----------------
gigabitethernet 2/1 down down Gi 2/1
This example shows statistics of the interfaces.
Ruijie# show interfaces gigabitethernet 1/2 counters
Interface : gigabitethernet 1/2
5 minute input rate : 9144 bits/sec, 9 packets/sec
5 minute output rate : 1280 bits/sec, 1 packets/sec
InOctets : 17310045
InUcastPkts : 37488
InMulticastPkts : 28139
InBroadcastPkts : 32472
OutOctets : 1282535
OutUcastPkts : 17284
OutMulticastPkts : 249
OutBroadcastPkts : 336
Undersize packets : 0
Oversize packets : 0
collisions : 0
Fragments : 0
Jabbers : 0
CRC alignment errors : 0
AlignmentErrors : 0
FCSErrors : 0
dropped packet events (due to lack of resources): 0
packets received of length (in octets):
64:46264, 65-127: 47427, 128-255: 3478,
256-511: 658, 512-1023: 18016, 1024-1518: 125
Showing the Optical Module Information
This section describes display commands and examples of optical modules. You can view the
optical module information by the show command in the privileged EXEC mode. Use the
following commands to show the optical module information in the privileged EXEC mode:
Command
Function
Ruijie# show interfaces
[interface-id] transceiver
Show the basic information for the optical
module on the specified interface.
Ruijie# show interfaces
[interface-id] transceiver alarm
Show the current alarm information for
the optical module on the specified
interface. If there is no alarm information,
it shows ―none‖.
Ruijie# show interfaces
[interface-id] transceiver
diagnosis
Show the optical module transceiver
diagnosis parameter on the specified
interface.