Ruijie RG-S2900G-E Series - Page 157

Configuration Guide Interface Configuration
The following example shows the optical module information on the interface GigabitEthernet
5/4:
Ruijie#show interfaces gigabitEthernet 5/4 transceiver
Transceiver Type : 1000BASE_SX_SFP
Connector Type : LC
Wavelength(nm) : 1310
Transfer Distance:
SMF fiber
-- 10km
EBW 50/125 um fiber
-- 300m
50/125 um fiber
-- 100m
62.5/125 um fiber
-- 33m
Digital Diagnostic Monitoring : YES
The following example shows the alarm information for the optical module on the interface
GigabitEthernet 5/4:
Ruijie#show interfaces gigabitEthernet 5/4 transceiver alarm
gigabitEthernet 5/4 transceiver current alarm information:
RX loss of signal
The following table shows the alarm information for the SFP optical modules:
Field
Description
SFP
RX loss of signal
Loss of the receiving signal.
RX power high
Alarm of the high receiving power of the optical
module.
RX power low
Alarm of the low receiving power of the optical
module.
TX fault
Sending fault.
TX bias high
Alarm of the bias high current.
TX bias low
Alarm of the bias low current.
TX power high
Alarm of the high sending power of the optical
module.
TX power low
Alarm of the low sending power of the optical module.
Temp high
Alarm of the high temperature.
Temp low
Alarm of the low temperature.