Ruijie RG-S2900G-E Series - Page 158

Configuration Guide Interface Configuration
Field
Description
Voltage high
Alarm of the high voltage.
Voltage low
Alarm of the low voltage.
Transceiver info
checksum error
Transceiver information checksum error.
Transceiver info I/O
error
Transceiver information read&write error
XFP
RX loss of signal
Loss of the receiving signal.
RX not ready
The receiving state is not ready.
RX CDR loss of lock
RX CDR loss of lock.
RX power high
Alarm of the high receiving power of the optical
module.
RX power low
Alarm of the low receiving power of the optical
module.
TX fault
Sending fault.
TX CDR loss of lock
TX CDR loss of lock.
TX bias high
Alarm of the bias high current.
TX bias low
Alarm of the bias low current.
TX power high
Alarm of the high sending power of the optical
module.
TX power low
Alarm of the low sending power of the optical module.
Module not ready
The module is not ready.
Temp high
Alarm of the high temperature.
Temp low
Alarm of the low temperature.
Voltage high
Alarm of the high voltage.