Ruijie RG-S2900G-E Series - Page 159

Configuration Guide Interface Configuration
Field
Description
Voltage low
Alarm of the low voltage.
Transceiver info
checksum error
Transceiver information checksum error.
Transceiver info I/O
error
Transceiver information read&write error
The following example shows the optical module transceiver diagnosis parameter on the
interface GigabitEthernet 5/4:
Ruijie#show interfaces gigabitEthernet 5/4 transceiver diagnosis
Current diagnostic parameters:
Temp(°C) Voltage(V) Bias(mA) RX power(dBM) TX power(dBM)
36(OK) 3.31(OK) 6.13(OK) -35.64(warning) -5.19(alarm)
The following table shows the optical module transceiver diagnosis parameter:
Field
Description
diagnostic
information
The diagnostic information for the optical module on
the interface.
Current diagnostic
parameters
Current diagnostic parameters
Temp.(°C)
The diagnostic parameter—temperature, in °C,
correct to 1°C.
Voltage(V)
The diagnostic parameter—voltage, in V, correct to
0.01 V.
Bias(mA)
The diagnostic parameter—bias current, in mA,
correct to 0.01 mA.
RX power(dBM)
The diagnostic parameter—RX power, in dBM.
TX power(dBM)
The diagnostic parameter—TX power, in dBM,
correct to 0.01 dBM.
OK
The current state is normal.
warning
The current state is warning.
alarm
The current state is alarm.