Ruijie RG-S2900G-E Series - Page 183

Configuration Guide MAC Address Configuration
Caution
In the IPV6 mode, DHCP Snooping address binding, port security MAC+IP
address binding functions are enabled at the same time.
Mode
IPv4 packet
forward
rule
IPv6 packet forward rule
Strict
Only
packets with
IPV4+MAC
are
forwarded.
Only IPV6 packets with IPv6 security
address configured are allowed to be
forwarded.
Loose
Only
packets with
IPV4+MAC
are
forwarded.
All IPV6 packets are aloowed to be
forwarded.
Compat
ible
Only
packets with
IPV4+MAC
are
forwarded.
Only IPV6 packets binded with the source
MAC address or the security address
configured are allowed to be forwarded.
Setting the Exceptional Ports for the IP Address and MAC Address Binding
To make the IP address and MAC address binding not to take effect on some
ports, you can set these ports as exceptional ports. To configure an exceptional
port, execute the following command in the global configuration mode.
Command
Function
Ruijie(config)#address-bind uplink
interface-id
Configure the exceptional port for the IP
address and MAC address binding.
Interface-id: port or Aggregate port
Use the no address-bind uplink interface-id command to cancel the
configuration of the specified exceptional port.
The following example shows how to set the interface GigabitEthenet 0/1 to the
exceptional port:
Ruijie#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# address-bind uplink GigabitEthernet 0/1