Configuration Guide Private VLAN Configuration
Ruijie(config-if)#switchport mode private-vlan promiscuous
Ruijie(config-if)#switchport private-vlan mapping 99 add 100-101
Ruijie(config-if)#exit
# Set a SVI(192.168.1.1) for Primary VLAN and map Secondary VLANs to the
L3 interface of Primary VLAN.
Ruijie(config)#interface vlan 99
Ruijie(config-if)#ip address 192.168.1.1 255.255.255.0
Ruijie(config-if)#private-vlan mapping 100-101
Ruijie(config-if)#show vlan private-vlan
VLAN Type Status Routed Ports Associated VLANs
----- ---------- -------- -------- -------------------------
99 primary active Enabled Gi0/4 100-101
100 community active Enabled Gi0/1, Gi0/2 99
101 isolated active Enabled Gi0/3 99
Private VLAN-supported Switch and Protected Port-supported Switch
Configuration
Configuration Requirement
Connect multiple switches supporting Protected Port to the switch supporting
Private VLAN and it is required that the hosts connected to the isolated ports or
protected ports of any switches are isolated. You can configure the Isolated
Trunk Port in the Private VLAN to implement the connection to the Trunk Port on
the protected port-supported switch.
To Next Page
Loading...
