Ruijie RG-S2900G-E Series - Page 296

Configuration Guide GVRP Configuration
Enable dynamic VLAN creation:
Command
Function
Ruijie(config)# [no] gvrp
dymanic-vlan-creation enable
Enable GVRP to create VLAN dynamically
(if it is disabled)
The user cannot change the parameters of dynamic VLANs created by GVRP.
Configuration example:
Ruijie# configure
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# gvrp dymanic-vlan-creation enable
Ruijie(config)# end
Configure the GVRP VLAN
In the context without STP (Spanning-tree protocol), all available ports can be GVRP
participants.
In the context with SST (Single Spanning-tree), only ports showing "Forwarding" state in
the current SST Context can be GVRP participants. In the context with MST (Multiple
Spanning-tree), GVRP can run in the Spanning-tree Context which VLAN 1 is affiliated
with, and the user cannot specify other Spanning-tree Contexts.
Configure Port Registration Mode
There are two port registration modes:
 GVRP Registration Normal
 GVRP Registration Disabled
Configuring a port in normal registration mode allows dynamic creation (if dynamic
VLAN creation is enabled), registration, and deregistration of VLANs on the port.
When a port is configured to "disabled registration" mode, no dynamic VLAN registration
or deregistration will be allowed.
Configure GVRP Registration Mode of port:
Command
Function
Ruijie(config-if)# [no] gvrp registration
mode {normal | disabled}
Configure GVRP registration mode of the
port
These two registration modes will not affect static VLANs on the port. The static VLANs
created by the user are always "Fixed Registrar".
Example of enabling Registration Mode on port 1:
Ruijie# configure