Ruijie RG-S2900G-E Series - Page 297

Configuration Guide GVRP Configuration
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# gvrp registration mode enable normal
Ruijie(config-if)# end
Configure Port Declaration Mode
There are two declaration modes to control whether the port will send GVRP declarations.
 GVRP Normal Applicant
Allowing the declaration of VLANs on the port, including all dynamic and static VLANs.
 GVRP Non-Applicant
Prohibiting the declaration of VLANs on the port.
Configure declaration mode of the port:
Command
Function
Ruijie(config-if)# [no] gvrp applicant
state {normal | non-applicant}
Configure GVRP declaration mode of the
port
Example of configuring Applicant Mode on port 1:
Ruijie# configure
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# gvrp applicant state normal
Ruijie(config-if)# end
Configure GVRP Timers
GVRP uses three timers:
1. Join Timer
Join timer controls the maximum latency before the port sends declaration, and the actual
sending interval will range between 0 and this maximum latency. The default value is
200ms.
2. Leave Timer
Leave Timer controls the time required to delete port from VLAN after receiving the Leave
Message. If the port receives Join Message again during this period, then the port will
maintain VLAN membership, and the timer become void. If the port doesn't receive Join
Message before the timer runs out, then the port will be deleted from the VLAN
membership table. The default value is 600ms.
3. LeaveAll Timer
LeaveAll Timer controls the minimum interval to send LeaveAll Message on the port. If the
port receives LeaveAll Message before the timer runs out, then the timer will start timing