Ruijie RG-S2900G-E Series - Page 579

Configuration Guide WEB Authentication Configuration
Ruijie(config)# snmp-server community web-auth rw
Ruijie(config)# snmp-server enable traps web-auth
Ruijie(config)# snmp-server host 176.10.0.1 informs version 2c web-auth web-auth
The SNMP communication parameters listed herein are based on SNMPv2. If higher
security is required for the SNMP communication between device and Portal Server,
SNMPv3 is suggested. In such a case, SNMP Community should be set as SNMP User,
and the version of SNMP-Inform should be changed into SNMPv3. In addition, SNMPv3
related security parameters should also be set. Please refer to “SNMP Configuration” for
details.
Viewing Configurations
Command
Function
show http redirect
Display the configuration of Portal Server.
Configuring Relevant Parameters of Ruijie Second Generation Web
Authentication
By default, the second generation web authentication is disabled. Likewise, to use the second generation
web authentication, you have to configure relevant parameters. The following sections describe how to
configure parameters of the second generation web authentication:
 Creating Portal Server
 Configuring AAA Authentication Method List of Web authentication
 Configuring AAA Accounting Method List of Web authentication
 Configuring the Communication Key Used Between Device and Portal Server
 Configuring Global Authentication Method List (Optional)
 Configuring Global Portal Server (Optional)
 Configuring Accounting Update Interval (Optional)
Creating Portal Server
To successfully apply the second generation web authentication, at least one Portal Server should be
created
By default, there is no information about Portal Server. To create a Portal Server, perform the following
steps:
Command
Function
Ruijie# configure terminal
Enter the global configuration mode.