Configuration Guide System Upgrade Configuration
Upon completion of automatic installation, the system will reset the device
automatically.
SYS-5-RESTART: The device is restarting. Reason: Upgrade product !.
After the reset, the device will enter into ready state.
Automatic Upgrade of Chassis Device
Upgrade steps
Steps to upgrade the chassis device:
Copy the new-version software to the device
Reset the device
Wait for device installation
Upgrade to 10.4(2) or higher version
Copy the new-version software to the device:
Ruijie#copy tftp://192.168.201.97/rgos.bin flash:rgos.bin
Accessing tftp://192.168.201.97/rgos.bin...
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!Checkin
g file, please wait for a few minutes ....
Check file success.
Transmission finished, file length 22655264
THE PROGRAM VERSION: RGOS 10.4.*, Release(64046)
Upgrade file to Module(s) in slot: [M2]
Please wait......
Upgrade file to Module in slot [M2] OK!
Upgrade Master CM main program OK.
CURRENT PRODUCT INFORMATION :
PRODUCT ID: 0x20060062
PRODUCT DESCRIPTION: Ruijie High-density IPv6 10G Core Routing Switch(S8610)
By Ruijie Network
To Next Page
Loading...
