Configuration Guide System Upgrade Configuration
SUCCESS: UPGRADING OK.
Reset the device:
Ruijie#reload
Wait for automatic installation of device:
After entering the main program, the main management board will implement local
installation first:
*Apr 1 07:32:17: %UPGRADE-5-LOCAL_BEG: Installing: 'flash: CTRL'.
*Apr 1 07:32:17: %UPGRADE-5-LOCAL: Upgrading CTRL.
Upgrading CTRL...
DO NOT POWER OFF!
Erasing device...eeeeeeeeeeeeeeeeeeeeeeeee [ok]
Writing flash #################### [OK - 1,215,488 bytes]
*Apr 1 07:32:44: %UPGRADE-5-LOCAL_FIN: New software image installed in
flash.
Upon completion of local installation, the system will verify whether the boot/ctrl/main
programs of all line cards and the slave board need to be installed and complete the
corresponding installation automatically. This automatic installation process will
generally take place when the current device version is lower than 10.4(2).
These images in linecard will be updated:
Slot image linecard
---- ----- ----------------
3 MAIN M8600-24GT/12SFP
M2 CTRL M8610-CM II
--------------------------------
*Aug 7 07:46:25: %UPGRADE-5-SLOT_BEG: (Slot 3): Installing MAIN
(Slot 3): Download image
*Aug 7 07:47:21: %UPGRADE-5-SLOT_SUCC: (Slot 3): MAIN installed.
*Aug 7 07:47:21: %UPGRADE-5-SLOT_FIN: (Slot 3): All images is installed.
*Aug 7 07:47:21: %UPGRADE-5-RESET_CARD: (Slot 3): Reset.
*Aug 7 07:47:26: %UPGRADE-5-SLOT_BEG: (Slot M2): Installing CTRL
(Slot M2): Download image!!!!!!!!!!!!!!!!!!!![OK - 1,215,232 bytes]
Waiting for image installed...Complete
Erasing device...eeeeeeeeeeeeeeeeeeeeeeee [ok]
Writing flash ################# [OK - 1,215,488 bytes]
*Aug 7 07:48:00: %UPGRADE-5-SLOT_SUCC: (Slot M2): CTRL installed.
*Aug 7 07:48:00: %UPGRADE-5-SLOT_FIN: (Slot M2): All images is installed.
*Aug 7 07:48:00: %UPGRADE-5-RESET_CARD: (Slot M2): Reset.
To Next Page
Loading...
