Ruijie RG-S2900G-E Series

Configuration Guide System Upgrade Configuration

The upgrade of old-version line card will need two reboots. The line card will reboot

automatically after the main program has been installed. After reentering the main

program, the boot or ctrl image will be installed.

These images in linecard will be updated:

Slot image linecard

---- ----- ----------------

3 CTRL M8600-24GT/12SFP

-------------------------------------

*Aug 7 07:48:09: %UPGRADE-5-SLOT_BEG: (Slot 3): Installing CTRL

(Slot 3): Download image!!!!!!!!!!!!!!!!!![OK - 1,087,744 bytes]

Waiting for image installed...Complete

Erasing device...eeeeeeeeeeeeeeeeeeeeeeeeee [ok]

Writing flash ################ [OK - 1,088,0 bytes]

*Aug 7 07:48:37: %UPGRADE-5-SLOT_SUCC: (Slot 3): CTRL installed.

*Aug 7 07:48:37: %UPGRADE-5-SLOT_FIN: (Slot 3): All images is installed.

*Aug 7 07:48:37: %UPGRADE-5-RESET_CARD: (Slot 3): Reset.

Upon completion of installation, normal services can start directly without the need to

reset the device.

Degrade to 10.4(1) or older version

Copy the new-version software to the device:

Use "copy" command to copy the old edition software of 10.4(1) to the device.

Ruijie#copy tftp://192.168.201.97/rgos.bin flash:rgos.bin

Accessing tftp://192.168.201.97/ rgos.bin ...

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Transmission finished, file length 22815872 bytes.

Verify the system boot image .....[ok]

Upgrading system boot image on slave:/

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Ruijie RG-S2900G-E Series - Page 63