Ruijie RG-S2900G-E Series - Page 662

Configuration Guide ND Snooping Configuration
Ruijie(config)# ipv6 nd snooping
Configuring ND Attack Protection
Configuring Interface Trust State
By default, the trust state of all interfaces is set to untrust. You may use the following command to set
the trust state of a certain interface to trust:
Command
Function
Ruijie# configure terminal
Enter the global configuration mode.
Ruijie(config)# Interface interface_id
Enter the interface configuration mode.
Ruijie(config-if)# ipv6 nd snooping trust
Set the IPv6 ND Snooping trusted interface.
For example: set interface FastEthernet 0/1 to Trust interface.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# interface fastethernet 0/1
Ruijie(config-if)# ipv6 nd snooping trust
Displaying ND Snooping
Displaying ND Snooping Configurations
Command
Function
Ruijie# show ipv6 nd snooping
[interface]
Display the ND snooping configurations.
Interface: only display interface information.
For example: display ND Snooping configurations
Ruijie# show ipv6 nd snooping
Ruijie# show ipv6 nd snooping
Global switch: enabled
ND Snooping is disabled in following VLANs:
None
Address resolution check: disabled, software
Route information check: enabled, software
Stateless-user monitor: disabled
Stateless-user bind: disabled, loose, IP-only
Interface Trusted Combine-security
--------- ------- ----------------