Ruijie RG-S2900G-E Series - Page 743

Configuration Guide NFPP Configuration
Showing dhcpv6-guard
 Showing dhcpv6-guard configuration
 Showing monitored host configuration
Showing dhcpv6-guard configuration
Use this command to show the dhcpv6-guard configurations.
Command
Function
Ruijie# show nfpp dhcpv6-guard
summary
Show the dhcpv6-guard
configurations.
For example,
Ruijie# show nfpp dhcpv6-guard summary
（Format of column Rate-limit and Attack-threshold is per-src-ip/per-src-
mac/per-port.）
Interface Status Isolate-period Rate-limit Attack-threshold
Global Enable 300 -/5/150 -/10/300
G 0/1 Enable 180 -/6/- -/8/-
G 0/2 Disable 200 -/5/30 -/10/50
Maximum count of monitored hosts: 1000
Monitor period：300s
Note
Field
Description
Interface
Global refers to the global configuration.
Status
Enable/disable the arp-guard.
Rate-limit
In the format of source IP address-based
rate-limit threshold / source MAC
address-based rate-limit threshold /
port-based rate-limit threshold.
Attack-threshold
In the same format of the Rate-limit.
-
No configuration.
Showing monitored host configuration
Command
Function
Ruijie# show nfpp dhcpv6-guard
hosts statistics
Show the dhcpv6-guard hosts statistics,
including total host amount, isolated host
amount and non-isolated host amount.