Ruijie RG-S2900G-E Series - Page 824

Configuration Guide SEM Configuration
Ruijie(SEM-applet)# description "policy_for_test"
Caution
The change to description will take effect immediately without the need to
submit.
Configure trigger parameters
Command
Function
Ruijie>enable
Enter privileged EXEC mode
Ruijie# configure terminal
Enter global configuration mode
Ruijie(config)# smart manager applet
applet-name [class class-options]
Enter SEM configuration mode.
applet-name is the specified policy
name.
class parameter specifies the policy
class.
Ruijie(SEM-applet)#trigger [occurs-value
occurs-value] [occurs-period
occurs-period-value] [correlate-start
period-start-value] [correlate-period
correlate-period-value] [delay delay-value]
[maxrun maxruntime-number]
Configure policy trigger parameters
To restore policy trigger parameters to default settings, execute "no trigger" command in
the SEM configuration mode.
Configuration example:
# Configure trigger parameters for a policy named "policy_a", so that it will be executed 5
seconds after being triggered, and the maximum running time shall be 15 seconds.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# smart manager applet policy_a
Ruijie(SEM-applet)# trigger delay 5 maxrun 15
Configure CLI Action Output Record
Command
Function
Ruijie>enable
Enter privileged EXEC mode
Ruijie# configure terminal
Enter global configuration mode