Configuration Guide SEM Configuration
Network topology
<NA>
Configuration tips
1) Create policy
2) Configure none event
3) Configure action
4) Submit policy configurations
Configuration steps
1） Configure Device A
a， Name the policy configured for Device A as "policy_a".
b， Configure an event named "event_1" for policy_a, with type being "none". This
event will be triggered manually by CLI.
c， Configure multiple actions for policy_a, as shown below:
Enter privileged EXEC mode;
Execute "clear arp-cache" to clear ARP cache;
Execute "clear ip route *" to refresh IPv4 routing table;
Execute "clear ipv6 route *" to refresh IPv6 routing table;
d， Submit the policy
e， End policy editing
Ruijie# configure terminal
Ruijie(config)# smart manager applet policy_a
Ruijie(SEM-applet)# event tag event_1 none
Ruijie(SEM-applet)# action action_1 cli command "enable"
Ruijie(SEM-applet)# action action_2 cli command "clear arp-cache"
Ruijie(SEM-applet)# action action_3 cli command "clear ip route *"
Ruijie(SEM-applet)# action action_4 cli command "clear ipv6 route *"
Ruijie(SEM-applet)# commit
Ruijie(SEM-applet)# exit
Ruijie(config)#
Verification
Ruijie# show smart manager policy registered
No. Class Event Type Time Registered Name
1 applet none Mon Mar 8 21:43:07 2010 policy_a
To Next Page
Loading...
