Ruijie RG-S2900G-E Series - Page 837

Configuration Guide SEM Configuration
4) Submit policy configurations
Configuration steps
1） Configure Device A
a， Name the policy configured for Device A as "policy_a".
b， Configure an event named "event_1" for policy_a, with type being "SNMP
Object". Detailed parameters are shown below:
Detect OID of SNMP operations: "oid 1.3.6.1.2.1.2.1";
OID must not be of table type: "istable no";
OID type must be int: "type int";
The asynchronization mode must be used to execute the policy, skip SNMP
Object operations, and use the parameter "skip yes".
c， Configure actions for policy_a: the snmp operation of record is cancelled.
d， Submit the policy
e， End policy editing
Ruijie# configure terminal
Ruijie(config)# smart manager applet policy_a
Ruijie(sem-applet)# event tag event_1 snmp-object oid 1.3.6.1.2.1.2.1 istable no
type int skip yes
Ruijie(sem-applet)# action action_1 syslog msg "cancel snmp operate" priority 5
Ruijie(sem-applet)# commit
Ruijie(sem-applet)# exit
Ruijie(config)#
Verification
Ruijie# show smart manager policy registered
No. Class Event Type Time Registered Secu Name
1 applet snmp-object Tue Mar 9 17:46:01 2010 none policy_a
event_1: snmp-object: oid 1.3.6.1.2.1.2.1 type int skip yes istable no
maxrun 20.000
action action_1 syslog msg "cancel snmp operate"
SEM detection of none event
Networking requirements
During the installation and troubleshooting of Device A, the routing table, ARP table and
IPv6 routing table must be cleared repeatedly. A simple method is needed to realize
batch operations.