Ruijie RG-S2900G-E Series - Page 896

Configuration Guide ERSPAN Configuration
 In case of bidirectional monitoring of multiple ports, you only need to monitor
one flow direction of packets.
 You can monitor the incoming and outgoing packets on the STP-enabled port in
the block state.
 The source port and the destination port can belong to the same VLAN or
different VLANs.
Command
Function
Ruijie(config-mon-erspan-src)#
source {interface single_interface}
[rx | tx | both]}
Show the mirrored source port.
Enabling the ERSPAN Session
By default, the ERSPAN mirroring is enanled. To enable the ERSPAN session, run
the following commands:
Command
Function
Ruijie (config-mon-erspan-src)#
shutdown
Ruijie (config-mon-erspan-src)# no
shutdown
Disable the ERSPAN mirroring.
Enable the ERSPAN mirroring.
Configuring the Encapsulated Source IP Address
The encapsulated source IP address is used for the source IP address of
GRE-encapsulated packets.
Command
Function
Ruijie(config-mon-erspan-src)#
origin ip address ip-address
Configure the encapsulated source IP
address.