● Read the unpacking instructions carefully before unpacking the instrument.
When removing the instrument from the pallet, two or more persons should work together because
the instrument weighs 150 kg. When removing the instrument from the pallet this way, indicate so in
the shipping document and inspect the cargo for damage. As a rule, the instrument is
unpacked/installed by Sakura Finetek or our local representative.
● Those who have experience operating a Sakura Finetek product or products other than the
instrument must also read this manual. Also, those who will be operating the instrument
should receive training first.
Sakura Finetek will assume no responsibility for any accident that may result from an accident
caused by operating the instrument without reading this manual first. If the instrument is operated in
a manner not specified in this document, the protective functions of the equipment may be lost.
● Do not apply unnecessary external forces on the instrument and accessories.
The instrument may malfunction or cause accidents.
● Avoid connecting the instrument to a transformer not manufactured by Sakura Finetek.
When moving the instrument to a region where different voltage is used, contact the Sakura Finetek
Technical Support representative or local representative.
● Safety mechanisms installed in the instrument only represent the minimum measures taken
to prevent accidents. The responsibility for safe operation of the instrument lies primarily
with the owner of the instrument, and persons in charge who operate the instrument.
● Do not use the instrument, if damaged, even when operating it is possible.
Injury or electric shock may result.
● Should the instrument malfunction, turn off the power and disconnect the power plug from
the power outlet. If processing is still in progress, immediately protect the tissues.
Should malfunction occur, turn off the power and contact the Sakura Finetek Technical Support
representative or local representative. Disconnecting the power plug also cuts off the main power
supply. When installing the instrument, select a place where the power outlet is not concealed and
the power plug can be disconnected any time in case of emergency.
● Do not disassemble or modify the instrument.
The instrument may malfunction or cause accident, thus creating a dangerous situation.
● Only the specified solutions can be used with this instrument.
If any other solution is used, processing may not be performed properly and fire or failure may
result.
● Do not wet the instrument.
If areas other than those instructed by "Daily Inspection and Care" get wet, current leak may occur
and cause fire or electric shock. If wetted, the board, power switch, CF card and CF card slot,
connection parts of various terminals art located on the right side of the instrument may cause
instrument failure or data damage.
If the terminal connection part LAN or bar code terminal is not used, put a protective cap over it.
To Next Page
Loading...
Need help?
General
