Sanyo PDG-DHT8000L - 8000 Lumens - 5 Functional Execution Command Table; Image Command Table; PC Control Command Table

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
13/101
5． Functional Execution Command Table
5.1 Image Command Table
Execute command Item
CF_CONT_%1[CR] Set value of Contrast
CF_BRIGHT_%1[CR] Set value of Brightness
CF_COLOR_%1[CR] Set value of Color
CF_TINT_%1[CR] Set value of Tint
CF_COLMNSAV_%1[CR] Set area to store current values of Color Management
CF_COLMNLD_%1[CR] Set area to load values of Color Management
CF_APCTRL_%1[CR] Set level of Auto Picture Control
CF_COLTEMP_%1[CR] Set level of Color Temperature
CF_WBAL-R_%1[CR] Set Red value of White Balance
CF_WBAL-G_%1[CR] Set Green value of White Balance
CF_WBAL-B_%1[CR] Set Blue value of White Balance
CF_OFFSET-R_%1 [CR] Set Red value of Offset
CF_OFFSET-G_%1 [CR] Set Green value of Offset
CF_OFFSET-B_%1 [CR] Set Blue value of Offset
CF_SHARP_%1[CR] Set value of Sharpness
CF_GAMMA_%1[CR] Set value of Gamma
CF_NZRED_%1[CR] Set ON/OFF of Noise reduction
CF_PROGV_%1[CR] Set mode of Progressive scan
CF_BCOLOR_%1[CR] Set ON/OFF of Brilliant Color
CF_IMAGE_%1[CR] Set Image mode
CF_IMAGEADJ_%1[CR] Set Store/Reset of values in Image Adjustment
5.2 PC Control Command Table
Execute command Item
CF_FSYNC_%1[CR] Set value of Fine Sync
CF_TDOTS_%1[CR] Set value of Total Dots
CF_H-POS_%1[CR] Set value of Horizontal Position
CF_V-POS_%1[CR] Set value of Vertical Position
CF_CLAMP_%1[CR] Set value of Clamp
CF_DDOTS_%1[CR] Set value of Display Dots
CF_DLINE_%1[CR] Set value of Display Line
CF_SETPCADJ_%1[CR] Apply values set in PC Adjust menu to screen image
CF_ORGMODE_%1[CR] Specify the original signal for the selected PC mode
CF_PCSTORE_%1[CR]
Store current setting values in PC Adjust menu to
Mode %1
CF_PCMODEFREE_%1
[CR]
Delete the values registered in Mode %1 and return it to
Free status.