Sanyo PDG-DHT8000L - 8000 Lumens - CR_MODELIST Command; CR_SRCINP1 Command; CR_SRCINP2 Command; CR_SRCINP3 Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
72/101
9.7.5 CR_MODELIST Command
Command “CR_MODELIST” [CR]
Details Get possible modes for Mode list
Acceptable “000_%1_%2_---_%x” [CR]
%1
Error Code “101” is returned except for PC-Analog and for no
signal with PC-Analog
Possible modes in Mode1-10 are returned when PC-Analog
signal is coming.
“MODE1”
“MODE2”
“MODE3”
:
:
“MODE8”
“MODE9”
“MODE10”
Response
Unacceptable “Error Code” [CR]
9.7.6 CR_SRCINP1 Command
Command “CR_SRCINP1” [CR]
Details Get Source of Input1
Acceptable “000_%1” [CR]
%1
“DIGITAL” ---------------------- in Computer mode
“ANALOG”“ -------------------- in Computer mode
“VIDEO” ------------------------- in Video mode
“S-VIDEO” ---------------------- in Video mode
“YPBPR” ------------------------ in Component mode
“SDI1” --------------------------- in DF-SDI1 mode
“SDI2” --------------------------- in DF-SDI2 mode
“HDCP” ------------------------- in HDCP mode
“HDMI” -------------------------- in HDMI mode
“SCART”------------------------- in SCART mode
“BLANK” ------------------------ There is no input source
“NOCARD” --------------------- There is no board inserted
Response
Unacceptable “?” [CR]
9.7.7 CR_SRCINP2 Command
Command “CR_SRCINP2” [CR]
Details Get Source of Input 2
Acceptable “000_%1” [CR]
%1 The same data as CF_SRCINP1
Response
Unacceptable “?” [CR]
9.7.8 CR_SRCINP3 Command
Command “CR_SRCINP3” [CR]
Details Get Source of Input 3
Acceptable “000_%1” [CR]
%1 The same data as CF_SRCINP1
Response
Unacceptable “?” [CR]