PDG-DHT8000L Expand Serial Command Functional Specifications
52/101
8.9.47 CF_PJPINCODE Command
Command
“CF_PJPINCODE_%1” [CR]
%1 “0000 – 9999” ------------- Directly specify PJ PIN code
Details
Enter PIN code to cancel PIN code lock (Available only in the normal Power ON
status)
PIN code can not be changed. (Only PIN code lock is canceled.)
*When PIN code Lock is enabled:
PIN code is matched ------------------------- Command is valid (Acceptable)
PIN code is mismatched -------------------- Command is invalid (Error code “102”)
PIN code is beyond %1 available range ----- Command is invalid (Error code “?”)
*When PIN code lock is canceled:
PIN code is within %1 range ----------- Command is valid (Acceptable)
PIN code is out of %1 range ----------- Command is invalid (Error code is 102)
This command is only valid when “PJ PIN code” dialog is displayed to enter PIN
code after Power is ON and Countdown is completed.
When PIN code lock is set to “On1”, it needs to send this command every time the
projector is turned on.
Acceptable “000” [CR]
Response
Unacceptable
“Error Code” [CR]
8.9.48 CF_FILH Command
Command
“CF_FILH_%1” [CR]
%1 “RST” ---------------------- Reset Filter used time
Details Reset used time for filter of projector
Acceptable “000” [CR]
Response
Unacceptable
“Error Code” [CR]
8.9.49 CF_FILTIMER Command
Command
“CF_FILTIMER_%1” [CR]
%1
“1000” ---------------------- Set 1000 hours
“2000” ---------------------- Set 2000 hours
“3000” ---------------------- Set 3000 hours
“OFF” ---------------------- Set Off(Do not warning display)
Details Set time to display Filter cleaning / replacement warning on screen
Acceptable “000” [CR]
Response
Unacceptable
“Error Code” [CR]
8.9.50 CF_FILCTL Command
Command
“CF_FILCTL_%1” [CR]
%1 “ROLL” ---------------------- Execute operation of scroll of filter
Details Execute operation of scroll of filter
Acceptable Acceptable
Response
Unacceptable
Unacceptable
To Next Page
Loading...
