Sanyo PDG-DHT8000L - 8000 Lumens - CF_CCAPTIONCOLOR Command; CF_FRAMELOCK Command; CF_FRAMELOCKADJ Command; CF_FRAMELOCKRST Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
56/101
8.9.62 CF_CCAPTIONCOLOR Command
Command “CF_CCAPTIONCOLOR _%1” [CR]
%1
“COLOR” ------- Select Color
“WHITE” -------- Select White
Details
Select color of Closed caption.
The status set with this command is stored in EEPROM and its setting is effective
even after ALL is OFF. This command is available in normal Power ON status.
Note)Closed caption is available under conditions below;
Entered signal is appropriate (Video, NTSC signal of S-video) and System is fixed
to NTSC.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.63 CF_FRAMELOCK Command
Command “CF_FRAMELOCK_%1” [CR]
%1
“AUTO” --- Set Frame lock function to Auto.
“23.98” --- Set Frame lock to “Manual, 23.98 Hz.”
“25.00” --- Set Frame lock to “Manual, 25.00 Hz.”
“29.97” --- Set Frame lock to “Manual, 29.97 Hz.”
“30.00” --- Set Frame lock to “Manual, 30.00 Hz.”
“50.00” --- Set Frame lock to “Manual, 50.00 Hz.”
“59.94” --- Set Frame lock to “Manual, 59.94 Hz.”
“60.00” --- Set Frame lock to “Manual, 60.00 Hz.”
Details
Set Frame lock function to Auto or Manual.
(Valid only when in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.64 CF_FRAMELOCKADJ Command
Command “CF_FRAMELOCKADJ_%1” [CR]
%1
“UP” ----------------------- Search frame lock frequency upward.
“DN” ---------------------- Search frame lock frequency downward.
Details
Search Frame lock frequency and set manually.
(Valid only when in the normal Power ON status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.65 CF_FRAMELOCKRST Command
Command “CF_FRAMELOCKRST_%1” [CR]
%1 “RST” --- Reset Frame lock frequency
Details
Reset the setting of Frame lock.
(Valid only when in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]