Sanyo PDG-DHT8000L - 8000 Lumens - CR_BACKGND Command; CR_LOGO Command; CR_LOGOLOCK Command; CR_FANSPEED Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
82/101
9.10.5 CR_BACKGND Command
Command “CR_BACKGND” [CR]
Details Get setting status of Screen for no signal
Acceptable “000_%1” [CR]
%1
“BLUE” -------------------------------- Blue Back is selected
“USER” ------------------------------- User is selected
“BLACK” ------------------------------ Black Back is selected
Response
Unacceptable “Error Code” [CR]
9.10.6 CR_LOGO Command
Command “CR_LOGO” [CR]
Details Get Logo setting status
Acceptable “000_%1” [CR]
%1
“DFLT” ----------------------------- Default Logo is enabled
“USER” --------------------------- User is enabled
“OFF” ------------------------------ Off is enabled
Response
Unacceptable “?” [CR]
9.10.7 CR_LOGOLOCK Command
Command “CR_LOGOLOCK” [CR]
Details Get setting status of Logo Lock function
Acceptable “000_%1” [CR]
%1
“ON” --------------------------- Logo Lock is ON
“OFF” ------------------------- Logo Lock is OFF
Response
Unacceptable “Error Code” [CR]
9.10.8 CR_FANSPEED Command
Command “CR_FANSPEED” [CR]
Details Get currently selected Fan Control Speed
Acceptable “000_%1” [CR]
%1
“MAX” -------------------- Max speed of Fan Control is selected
“NOR” -------------------- Normal speed of Fan Control is selected
Response
Unacceptable “?” [CR]
9.10.9 CR_RCODE Command
Command “CR_RCODE” [CR]
Details Get currently selected Remote Control code
Acceptable “000_%1” [CR]
%1
“001” -------------------------- Code1
:
“008” -------------------------- Code8
Response
Unacceptable “?” [CR]