PDG-DHT8000L Expand Serial Command Functional Specifications
78/101
9.9 Lamp Status Read Commands
9.9.1 CR_LAMPREPL Command
Command
“CR_LAMPREPL” [CR]
Details Get the information of Lamp Replacement time
Acceptable “000_%1” [CR]
%1
“2**”
2 ---------------- indicates 2 lamps are used in this model.
* ---------------- indicates the status of each lamp in lamp number
order.
“Y” means the lamp operating time is over the
threshold for lamp replacement, and “N” means
it has not reached to.
e.g.
“2YN” ------------ This indicates it is 2-lamp system, and Lamp #2
has not been reached to the replacement time
while #1 should be replaced.
Response
Unacceptable
“?” [CR]
9.9.2 CR_LAMPMODE Command
Command
“CR_LAMPMODE” [CR]
Details Get Lamp mode setting status
Acceptable “000_%1” [CR]
%1
“FULL” ---------------- Lamp mode is set to 2-lamp (FULL)
“LAMP1”-------------- Lamp mode is set to Lamp1
“LAMP2” ------------- Lamp mode is set to Lamp2
Response
Unacceptable
“?” [CR]
9.9.3 CR_AUTOLAMPCONTRL Command
Command
“CR_AUTOLAMPCONTRL” [CR]
Details Get selected Lamp control mode
Acceptable “000_%1” [CR]
%1
“NORMAL” ---------- NORMAL is selected.
“ECO1” --------------- ECO1 is selected.
“ECO2” --------------- ECO2 is selected.
Response
Unacceptable
“Error Code” [CR]
9.9.4 CR_LAMPSTS Command
Command
“CR_LAMPSTS” [CR]
Details Get the information of Lamp lighting status
Acceptable “000_%1” [CR]
%1
“2**”
The first character indicates 2 lamps are used in this model.
The following characters indicate each lamp status in lamp
number order as showed below.
“I” ------------------------ Lamp is ON
“O” ---------------------- Lamp is OFF
“X” ----------------------- Lamp Failure
e.g.
“2IO” ------------------- This indicates it is 2-lamps system, Lamp
#1 is ON, and #2 is OFF.
Response
Unacceptable
“?” [CR]
To Next Page
Loading...
