Sanyo PDG-DHT8000L - 8000 Lumens - CF_DYNAMICBLACK Command; CF_HDMISETUP Command; CF_LOGO Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
49/101
8.9.38 CF_DYNAMICBLACK Command
Command “CF_DYNAMICBLACK_%1” [CR]
%1
“OFF” --------------------- Set to Off
“LOW” -------------------- Set to Low
“HIGH” ------------------- Set to High
Details
Set status of DynamicBlack.(Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.39 CF_HDMISETUP Command
Command “CF_HDMISETUP_%1” [CR]
%1
“NORMAL” ---------------------- Set to Normal
“ENHANCED” ------------------ Set to Enhanced
Details
Set status of HDMI setup.(Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.40 CF_LOGO Command
Command “CF_LOGO_%1_%2” [CR]
%1 “0000 – 9999” ------------- Directly set Logo PIN code
%2
“OFF” ---------------------------Cancel Logo display
“DFLT” ------------------------- Select Logo of Factory Default
“USER” ------------------------ Select User
“UP” ---------------------------- Select functions to choose forward
(OFF → DFLT → USER → OFF → --)
“DN” ---------------------------- Select functions to choose backward
            (OFF → USER → DFLT → OFF → --)
Details
Set Logo mode.(Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Set Logo PIN code in %1.
*When Logo Lock is enabled:
PIN code is matched ------------------------- Command is valid (Acceptable)
PIN code is mismatched-------------------- Command is invalid (Error code “102”)
PIN code is beyond %1 available range ------------ Command is invalid (Error
code”?”)
*When Logo Lock is disabled:
PIN code is within %1 available range ------- Command is valid (Acceptable)
PIN code is out of %1 available range ------- Command is invalid (Error code “?”)
Note: When Logo Lock is enabled, matching Logo PIN code switches Logo but
Logo Lock is not cancelled (Lock status is kept).
*When ％2=”USER” is received, error code “101” is returned, in the case of
Capture non-practice.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]