Sanyo PDG-DHT8000L - 8000 Lumens - PC Status Read Commands; CR_FSYNC Command; CR_TDOTS Command; CR_H-POS Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
64/101
9.5 PC Status Read Commands
9.5.1 CR_FSYNC Command
Command “CR_FSYNC” [CR]
Details Get value of Fine Sync
Acceptable “000_%1” [CR]
Response
%1 “0000” – “0031”
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] --------- When unknown command is received
9.5.2 CR_TDOTS Command
Command “CR_TDOTS” [CR]
Details Get value of Total Dots
Acceptable “000_%1” [CR]
%1
“mmmm” – “nnnn”
(mmmm = Display area H + Position H)
(nnnn = Maximum value less than 160 MHz of Dot Clock)
Response
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] --------- When unknown command is received
9.5.3 CR_H-POS Command
Command “CR_H-POS” [CR]
Details Get value of Horizontal Position
Acceptable “000_%1” [CR]
%1
“0000” – “ nnnn”
(nnnn = Total Dots - Display Area H)
Response
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] --------- When unknown command is received
9.5.4 CR_V-POS Command
Command “CR_V-POS” [CR]
Details Get value of Vertical Position
Acceptable “000_%1” [CR]
%1
“0000” – “ nnnn”
(nnnn = Total Line - Display Area V)
Response
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] --------- When unknown command is received