PDG-DHT8000L Expand Serial Command Functional Specifications
63/101
9.4.17 CR_BCOLOR Command
9.4.18 CR_IMAGE Command
Command
“CR_IMAGE” [CR]
Details
Get image setting status.
The Required data “CUSTOM1” – “CUSTOM10” corresponds to “Image1” –
“Image10” displayed when selecting Image on OSD Menu.
Acceptable “000_%1” [CR]
%1
“STAND” ----------------------------------- Standard
“REAL” ----------------------------------- Real
“CINEMA” --------------------------------- Cinema
“DYNAMIC” -------------------------------- Dynamic
“CUSTOM1” ------------------------------- “Image1”
“CUSTOM2” ------------------------------- “Image2”
“CUSTOM3” ------------------------------- “Image3”
“CUSTOM4” ------------------------------- “Image4”
“CUSTOM5” ------------------------------- “Image5”
“CUSTOM6” ------------------------------- “Image6”
“CUSTOM7” ------------------------------- “Image7”
“CUSTOM8” ------------------------------- “Image8”
“CUSTOM9” ------------------------------- “Image9”
“CUSTOM10” ----------------------------- “Image10”
Response
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] --------- When unknown command is received
9.4.19 CR_IMGGMD Command
Command
“CR_IMGGMD” [CR]
Details Get setting status of Standard/Real/Cinema/Dynamic in Image Gamma
Acceptable “000_%1” [CR]
%1
“STD” ------------------------------ Standard
“REL” ------------------------------ Real
“CNM” ----------------------------- Cinema
“DYN” ----------------------------- Dynamic
Response
Unacceptable
“?” [CR]
Command
“CR_PROGV” [CR]
Details Get BrilliantColor setting status
Acceptable “000_%1” [CR]
%1
“ON” ------------------------------ Set BrilliantColor to On
“OFF” ----------------------------- Set BrilliantColor to Off
Response
Unacceptable
“Error Code” [CR] -----------When command is invalid in the given
condition (such as being selected input)
“?” [CR] --------- When unknown command is received
To Next Page
Loading...
