Sanyo PDG-DHT8000L - 8000 Lumens - CR_PJLOCKNOW Command; CR_PJLOCMENU Command; CR_FILH Command; CR_FILCOND Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
84/101
9.10.15 CR_PJLOCKNOW Command
Command “CR_PJLOCKNOW” [CR]
Details Get actual setting status of PIN code lock
Acceptable “000_%1” [CR]
%1
“LOCK” ------ PJ is locked
PIN code lock is set to ON1/ON2 on the menu and PJ PIN code is
not entered, therefore PJ is actually locked.
“FREE” ------- PJ is unlocked (either A or B)
A) PJ lock is set to OFF on the menu
B) PJ lock is set to ON1/ON2 on the menu, but PIN code Lock
mode is canceled because PJ PIN code is entered.
Response
Unacceptable “Error Code” [CR]
9.10.16 CR_PJLOCMENU Command
Command “CR_PJLOCKMENU” [CR]
Details Get ON/OFF setting status of PIN code lock on menu
Acceptable “000_%1” [CR]
%1
“ON1” -------------------- PIN code lock ON 1 is set on the menu
“ON2” -------------------- PIN code lock ON 2 is set on the menu
“OFF” -------------------- PIN code lock OFF is set on the menu
Response
Unacceptable “Error Code” [CR]
9.10.17 CR_FILH Command
Command “CR_FILH” [CR]
Details Get Filter used time
Acceptable “000_%1” [CR]
%1 “00000 - 99999”
Response
Unacceptable “Error Code” [CR]
9.10.18 CR_FILCOND Command
Command “CR_FILCOND” [CR]
Details Get status of filter clog
Acceptable “000_%1” [CR]
%1
“CLOG” = Filter is clogged
“WARN” = Filter is nearly clogged
“CLEAN” = Filter is not clogged
Response
Unacceptable “Error Code” [CR]
9.10.19 CR_FILREPL Command
Command “CR_FILREPL” [CR]
Details Get status of Filter cleaning / replacement time
Acceptable “000_%1” [CR]
%1
“1Y”-------Filter Exchange time is over value of Filter Message.
“1N”--Filter Exchange time is not over value of Filter Message.
Response
Unacceptable “Error Code” [CR]