Sanyo PDG-DHT8000L - 8000 Lumens - CR_CMMSXY_%1 Command; CR_CMMSL_%1 Command; CR_CMTGXY_%1 Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
92/101
9.10.46 CR_CMMSXY_%1 Command
Command “CR_CMMSXY_%1” [CR]
Details Get “x”,”y” value of Measured of Color matching
Acceptable “000_%2_%3” [CR]
%1
“RED” ---------------------- value of Red is selected
“GREEN” ----------------- value of Green is selected
“BLUE” -------------------- value of Blue is selected
“WHITE” ------------------ value of White is selected
“HALFWHITE” ----------- value of Half white is selected
%2 “0000”-”1000”------------ “x” value of color of %1
%3 “0000”-”1000”------------ “y” value of color of %1
Response
Unacceptable “Error Code” [CR]
9.10.47 CR_CMMSL_%1 Command
Command “CR_CMMSL_%1” [CR]
Details Get “L” value of Measured of Color matching
Acceptable “000_%2” [CR]
%1
“RED” ---------------------- value of Red is selected
“GREEN” ----------------- value of Green is selected
“BLUE” -------------------- value of Blue is selected
“WHITE” ------------------ value of White is selected
“HALFWHITE” ----------- value of Half white is selected
%2 “0000”-”1000”------------ “L” value of color of %1
Response
Unacceptable “Error Code” [CR]
9.10.48 CR_CMTGXY_%1 Command
Command “CR_CMMTGXY_%1” [CR]
Details Get “x””y” value of Target of Color matching
Acceptable “000_%2” [CR]
%1
“RED” ---------------------- value of Red is selected
“GREEN” ----------------- value of Green is selected
“BLUE” -------------------- value of Blue is selected
“WHITE” ------------------ value of White is selected
“CYAN” -------------------- value of Cyan is selected
“MAGENTA” ------------- value of Magenta is selected
“YELLOW” --------------- value of Yellow is selected
%2 “0000”-”1000”------------ “x” value of color of %1
%3 “0000”-”1000”------------ “y” value of color of %1
Response
Unacceptable “Error Code” [CR]