Sanyo PDG-DHT8000L - 8000 Lumens - CF_HSCALE Command; CF_HPOS Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
36/101
8.7.9 CF_HSCALE Command
Command “CF_HSCALE_%1” [CR]
%1
“035” ---------------------- +35
“031” ---------------------- +31
：
“002” ---------------------- +2
“001” ---------------------- +1
“000” ---------------------- ±0
“‐01” ---------------------‐1
“‐02” ---------------------‐2
：
“‐31” ---------------------‐31
“‐32” ---------------------‐32
“UP” --------------------- Increment setting value of Hscale by 1
“DN” --------------------- Decrement setting value of Hscale by 1
Details
Set Hscale (Available only in the normal Power ON status)
*When selected screen mode is a setting except Custom, return “101” [CR] and
the command is not executed.
* When input is no signal, return “101” [CR] and the command is not executed.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.7.10 CF_HPOS Command
Command “CF_HPOS_%1” [CR]
%1
“015” --------------------- +15
“014” --------------------- +14
：
“002” --------------------- +2
“001” --------------------- +1
“000” --------------------- ±0
“‐01” ---------------------‐1
“‐02” ---------------------‐2
：
“‐14” ---------------------‐14
“‐15” ---------------------‐15
“UP” --------------------- Increment setting value of Hposition by 1
“DN” --------------------- Decrement setting value of Hposition by 1
Details
Set H Position (Available only in the normal Power ON status)
*When selected screen mode is a setting except Custom, return “101” [CR] and
the command is not executed.
* When input is no signal, return “101” [CR] and the command is not executed.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]