Sanyo PDG-DHT8000L - 8000 Lumens - CF_SHUTRELEASE Command; CF_DELAYCTRL Command; CF_CCAPTIONDISP Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
55/101
8.9.59 CF_SHUTRELEASE Command
Command “CF_SHUTRELEASE_%1” [CR]
%1
“ANY”----------Enable to release Shutter with any key
“SHUTTER” ------------------ Enable to release Shutter with only “SHUTTER” key
Details
Set Release key of Shutter.
(Valid only when in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.60 CF_DELAYCTRL Command
Command “CF_DELAYCTRL_%1” [CR]
%1
“OFF”---------- Set Video delay control to OFF
“LOW”---------- Set Video delay control to LOW
“MID”----------- Set Video delay control to MID
“HIGH”---------- Set Video delay control to HIGH
Details
Select the mode of Video delay control
(Valid only when in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.61 CF_CCAPTIONDISP Command
Command “CF_CCAPTIONDISP_%1” [CR]
%1
“OFF” ------------- Select Off
“CC1” ------------- Select CC1
“CC2” ------------- Select CC2
“CC3” ------------- Select CC3
“CC4” ------------- Select CC4
Details
Select channel of Closed caption.
The status set with this command is stored in EEPROM and its setting is effective
even after ALL is OFF. This command is available in normal Power ON status.
Note)Closed caption is available under conditions below;
Entered signal is appropriate (Video, NTSC signal of S-video) and System is fixed
to NTSC.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]