Sanyo PDG-DHT8000L - 8000 Lumens - Screen Status Read Commands; CR_SCREEN Command; CR_KYSTNMODE Command; CR_CEIL Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
76/101
9.8 Screen Status Read Commands
9.8.1 CR_SCREEN Command
Command “CR_SCREEN” [CR]
Details Get currently selected screen image size
Acceptable “000_%1” [CR]
%1
“NORMAL” ---------------------- Normal mode
“ZOOM” -------------------------- Zoom mode
“NATURAL” -------------------- Natural wide mode
“FULL” --------------------------- Full mode
“TRUE” --------------------------- True mode
“CUSTOM” ----------------------- Custom mode
Response
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] ----------------------- When unknown command is received
9.8.2 CR_KYSTNMODE Command
Command “CR_KYSTNMODE” [CR]
Details Get setting status of Keystone Store Mode
Acceptable “000_%1” [CR]
%1
“STR” ---------------------- Store mode is “Store”
“RST” ---------------------- Store mode is “Reset”
Response
Unacceptable “?” [CR] -------------------- When unknown command is received
9.8.3 CR_CEIL Command
Command “CR_CEIL” [CR]
Details Get setting status of Ceiling
Acceptable “000_%1” [CR]
%1
“ON” --------------------------- Ceiling projection is enabled
“OFF” ------------------------- Ceiling projection is disabled
Response
Unacceptable “Error Code” [CR]
9.8.4 CR_REAR Command
Command “CR_REAR” [CR]
Details Get setting status of Rear function
Acceptable “000_%1” [CR]
%1
“ON” --------------------------- Rear projection is enabled
“OFF” ------------------------- Rear projection is disabled
Response
Unacceptable “Error Code” [CR]
9.8.5 CR_VSCALE Command
Command “CR_VSCALE” [CR]
Details Get setting status of V scale
Acceptable “000_%1” [CR]
%1 “-32”−”035”
Response
Unacceptable “Error Code” [CR]