Sanyo PDG-DHT8000L - 8000 Lumens - CR_OFFSET-B Command; CR_SHARP Command; CR_GAMMA Command; CR_NZRED Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
62/101
9.4.12 CR_OFFSET-B Command
Command “CR_OFFSET-B” [CR]
Details Get user controlled Blue value of Offset
Acceptable “000_%1” [CR]
%1 “000” – “063”
Response
Unacceptable “?” [CR]
9.4.13 CR_SHARP Command
Command “CR_SHARP” [CR]
Details Get user controlled value of Sharpness
Acceptable “000_%1” [CR]
%1 “000” – “031”
Response
Unacceptable “?” [CR]
9.4.14 CR_GAMMA Command
Command “CR_GAMMA” [CR]
Details Get user controlled value of Gamma
Acceptable “000_%1” [CR]
%1 “000” – “015”
Response
Unacceptable “?” [CR]
9.4.15 CR_NZRED Command
Command “CR_NZRED” [CR]
Details Get Noise Reduction setting status
Acceptable “000_%1” [CR]
%1
“ON” --------------------------- Noise Reduction is ON
“OFF” ------------------------- Noise Reduction is OFF
Response
Unacceptable
“Error Code” [CR] -----------When command is invalid in the given
condition (such as being selected input)
“?” [CR] --------- When unknown command is received
9.4.16 CR_PROGV Command
Command “CR_PROGV” [CR]
Details Get Progressive scan setting status
Acceptable “000_%1” [CR]
%1
“ON” ------------------------------ Set Progressive scan On
“FILM” ----------------------------- Select FILM mode
“OFF” ------------------------------ Set Progressive scan Off
Response
Unacceptable
“Error Code” [CR] -----------When command is invalid in the given
condition (such as being selected input)
“?” [CR] --------- When unknown command is received