Sanyo PDG-DHT8000L - 8000 Lumens - Input Read Command; CR_INPUT Command; CR_SOURCE Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
69/101
9.7 Input Read Command
9.7.1 CR_INPUT Command
Command “CR_INPUT” [CR]
Details Get selected INPUT No.
Acceptable “000_%1” [CR]
%1 “1” – “4”
Response
Unacceptable “?” [CR]
9.7.2 CR_SOURCE Command
Command “CR_SOURCE” [CR]
Details Get selected Source
Acceptable “000_%1” [CR]
%1
“DIGITAL” --------------------- DVI Input is selected
“ANALOG --------------------- ANALOG RGB is selected
“VIDEO” ----------------------- Video Input is selected
“S-VIDEO” -------------------- S-VIDEO Input is selected
“YPBPR” ---------------------- Y/Pb/Pr Input is selected
“SDI1” ------------------------- DF-SDI1 Input is selected
“SDI2”-------------------------- DF-SDI2 Input is selected
“HDCP” ----------------------- HDCP Input is selected
“HDMI” ------------------------ HDMI Input is selected
“SCART” ---------------------- SCART Input is selected
“BLANK” ---------------------- without Source
“NOCARD” --------------------- There is no board inserted
Response
Unacceptable
“Error Code” [CR] -------------- When command is invalid in the
given condition (such as being selected input)
“?” [CR] --------- When unknown command is received