Sanyo PDG-DHT8000L - 8000 Lumens - CR_EDGEBLENDING Command; CR_BLENDBLK Command; CR_BLENDTESTPAT Command; CR_COLORMATCHING Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
91/101
9.10.42 CR_EDGEBLENDING Command
Command “CR_BLEND” [CR]
Details Get all values of width of Edge blending
Acceptable “000_%1_%2_%3_%4” [CR]
%1, %2,
%3, %4
Left width data comes first, and then one space, after that right
width data is followed.
%1 = Left width
%2 = Right width
%3 = Top width
%4 = Bottom width
e.g.
“100_100_100_100”[CR]
→Left = width 100
Right = width 100
Top = width 100
Bottom = width 100
Response
Unacceptable “Error Code” [CR]
9.10.43 CR_BLENDBLK Command
Command “CR_BLENDBLK” [CR]
Details Get all values of Black level of Edge blending
Acceptable “000_%1_%2_%3” [CR]
%1, %2,
%3
Data of red comes first, and then one space, after that data of
green is followed.
%1 = Red
%2 = Green
%3 = Blue
e.g.
“0100_0100_0100”[CR]
→Red = 100
Green = 100
Blue = 100
Response
Unacceptable “Error Code” [CR]
9.10.44 CR_BLENDTESTPAT Command
Command “CR_BLENDTESTPAT” [CR]
Details Get setting status of Test pattern of Edge blending
Acceptable “000_%1” [CR]
%1
“ON” ---------------------- On is selected
“OFF” --------------------- Off is selected
Response
Unacceptable “Error Code” [CR]
9.10.45 CR_COLORMATCHING Command
Command “CR_COLORMATCHING” [CR]
Details Get setting status of Color matching
Acceptable “000_%1” [CR]
%1
“ON” ---------------------- On is selected
“OFF” --------------------- Off is selected
Response
Unacceptable “Error Code” [CR]