Sanyo PDG-DHT8000L - 8000 Lumens - CR_SHUTRCPROT Command; CR_SHUTKEYPROT Command; CR_SHUTH Command; CR_SHUTEFFECT Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
86/101
9.10.24 CR_SHUTRCPROT Command
Command “CR_SHUTRCPROT” [CR]
Details Get status if Shutter can be controlled by R/C
Acceptable “000_%1” [CR]
%1
“ON” -------------------- Shutter is not controllable by R/C
“OFF” ------------------- Shutter is controllable by R/C
Response
Unacceptable “Error Code” [CR]
9.10.25 CR_SHUTKEYPROT Command
Command “CR_SHUTKEYPROT” [CR]
Details Get status if Shutter can be controlled by key on the side panel
Acceptable “000_%1” [CR]
%1
“ON” ---------- Shutter is not controllable by key on the side panel
“OFF” -------- Shutter is controllable by key on the side panel
Response
Unacceptable “Error Code” [CR]
9.10.26 CR_SHUTH Command
Command “CR_SHUTH” [CR]
Details Get time setting to start the shutter management
Acceptable “000_%1” [CR]
%1
“005” -------------------- 5minutes
“006” -------------------- 6minutes
:
“479” -------------------- 479minutes
“480” -------------------- 480minutes
Response
Unacceptable “Error Code” [CR]
9.10.27 CR_SHUTEFFECT Command
Command “CR_SHUTEFFECT” [CR]
Details Get status of Shutter effect function.
Acceptable “000_%1” [CR]
%1
“OFF” --------Fade in / out function is set to Off.
“L1” --------- Fade in / out function is set to L1.
“L2” --------- Fade in / out function is set to L2.
Response
Unacceptable “Error Code” [CR]
9.10.28 CR_SHUTRELEASE Command
Command “CR_SHUTRELEASE” [CR]
Details Get status of Shutter release key function.
Acceptable “000_%1” [CR]
%1
“ANY”-----------Enable to release Shutter with any key
“SHUTTER” -- Enable to release Shutter with only “SHUTTER”
key
Response
Unacceptable “Error Code” [CR]