Sanyo PDG-DHT8000L - 8000 Lumens - CR_P-TIMER Command; CR_TEMPWARN Command

PDG-DHT8000L Expand Serial Command Functional Specifications
                                       
96/101
9.11.5 CR_P-TIMER Command
Command “CR_P-TIMER” [CR]
Details Get Presentation Timer operating status
Acceptable “000_%1” [CR]
%1
“ON” ---------------------------- Presentation Timer is ongoing.
”STOP” ------------------------ Presentation Timer is paused.
“OFF” -------------------------- Presentation Timer is not active.
Response
Unacceptable “?” [CR]
9.11.6 CR_TEMPWARN Command
Command “CR_TEMPWARN” [CR]
Details
Get the information about the temperature inside the projector (close to the
abnormal or in the abnormal status/in the safe temperature level/abnormal status
is not detected).
It is possible to get the information about more than one sensor all at once if it is
applicable.
Acceptable “000_%1” [CR]
%1
“*_*”
Sensor 1 data comes first, and then one space, after that sensor
2 data is followed.
Each data is as below:
“W”--- in or close to the abnormal temp. (Warning Temp.)
“S”--- in the safe level of temperature (Safe Temp.).
“N”--- the given sensor does not detect abnormal temp.
e.g. “S_W” [CR] indicates that the temperature detected at
Sensor 1 is in the safe level while Sensor 2 in the abnormal
temperature.
Response
Unacceptable “?” [CR]