PDG-DHT8000L Expand Serial Command Functional Specifications
35/101
8.7.6 CF_REAR Command
Command
“CF_REAR_%1” [CR]
%1
“ON” --------------------------- Set Rear to ON
“OFF” ------------------------- Set Rear to OFF
Details
Set/Cancel Rear. (Valid only when in the normal Power ON status.)
When Rear is set to ON, image is left/right reversed.
The status set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.7.7 CF_VSCALE Command
Command
“CF_VSCALE_%1” [CR]
%1
“035” ---------------------- +35
“031” ---------------------- +31
：
“001” ---------------------- +1
“000” ---------------------- ±0
“‐01” ---------------------‐1
：
“‐31” ---------------------‐31
“‐32” ---------------------‐32
“UP” --------------------- Increment setting value of Vscale by 1
“DN” --------------------- Decrement setting value of Vscale by 1
Details
Set Vscale (Available only in the normal Power ON status)
*When selected screen mode is a setting except Custom, return “101” [CR] and
the command is not executed.
* When input is no signal, return “101” [CR] and the command is not executed.
Acceptable “000” [CR]
Response
Unacceptable
“Error Code” [CR]
8.7.8 CF_VPOS Command
Command
“CF_VPOS_%1” [CR]
%1
“015” --------------------- +15
“014” --------------------- +14
：
“001” --------------------- +1
“000” --------------------- ±0
“‐01” ---------------------‐1
：
“‐14” ---------------------‐14
“‐15” ---------------------‐15
“UP” --------------------- Increment setting value of Vposition by 1
“DN” --------------------- Decrement setting value of Vposition by 1
Details
Set V Position (Available only in the normal Power ON status)
*When selected screen mode is a setting except Custom, return “101” [CR] and
the command is not executed.
* When input is no signal, return “101” [CR] and the command is not executed.
Acceptable “000” [CR]
Response
Unacceptable
“Error Code” [CR]
To Next Page
Loading...
