Sartorius PR 5610 - Page 112

PR 5610 Installation Manual Commissioning with Terminal
Sartorius 109
5.1.3.1 Menu structure (tree)
With configuration on a serially connected terminal, the following menu is valid:
Main-Command-Level
- C Configuration
Configuration data
- D Set date
Enter date
- T Set time
Enter time
- C Change serial port parameter
Change port parameters
- L Add, delete, show license
License handling
- S Set software configuration
Configuration data
- U Set units
Entry of user-defined units
- F Set fieldbus configuration
Fieldbus configuration
- P Print all configuration data
Print
- E Exit
Return to higher level
- W Weighingpoint
Weight display and function keys
- 0 Set Zero
Set gross weight to zero
- I Tare In
Set tare
- O Tare Out
Reset tare
- T Tare
Display tare weight
- G Gross
Display gross weight (B, G if [W&M]=[NTEP])
- N Net
Display net weight
- ? Test
Test
- F Flow
Display weight change/minute
- Z Zeroset
Display zeroset (actual zero - initial zero)
- D Diff
Display difference weight
- S Setp
Display setpoint
- P Print
Print
- C Calib/Config
Access calibration (configuration) mask
- A Assign weighingpoints
Assign weighing points
- E Exit
Return to higher level
- S Service
- H Show hardware configuration
Display hardware configuration
- M Show available memory
Display memory occupation
- T Test Inputs/Outputs
Test I/Os in slot 1 - 4
- F Show last fault
Show last fault
- B show Bios version
Show bios version
- P Print all configuration data
Print configuration data
- E Exit
Return to higher level
- L Commandline
For entering IEC 61131 commands
- Q Quit
Terminate terminal mode