Commissioning with Terminal PR 5610 Installation Manual
108 Sartorius
5.1.2.2 Switch-on messages
The terminal output after instrument switch-on is the initialization message, followed by the main screen:
Instrument and version message, date/ time, main menu, see chapter 5.1.3.
5.1.2.3 Terminate terminal emulation program
Before switching on the PC or before closing the terminal emulation program, return to the main menu.
⇒ If the PC is switched off in a sub-menu instead of the main menu, the full mask may not be displayed when
starting the terminal emulation program. In particular, information on the operating and editing functions
are missing. Press space bar to display the mask at full size.
5.1.3 Main-Command-Level menu structure
After starting the terminal emulation program the following mask appears:
(If not all items are displayed, press the space bar on the keyboard)
PR1713 Rel. 03.12 20.05.2004 09:05
Main-Command-Level Mo 05.July 2004 09:31:51
C Configuration
W Weighingpoint
S Service
L Commandline
Q Quit
Access to the various input masks (survey, see Table of menu structure below) from this main menu (
Main-
Command-Level
) is via sub-menus. Calling up the required sub-menus is by pressing the relevant key [C], [W],
[S] or [L].
• Configuration
C Configuration
• Weighing point
W Weighingpoint
• Service
S Service
• Commandline
L
Commandline
• Leaving the main menu
Q Quit
⇒ If a production is active, the configuration is disabled:
Production is active, no configuration possible. Hit any key to continue
Press any key to remove this message from the display.
⇒ The entry of Q can be disabled:
Set in PR5610 [Setup]-[Software Parameter]-[Quit in mainlevel] to [disabled], then the menu item for Quit
is removed from the screen.
⇒ If [Quit in mainlevel] has been set to [enabled] and the Q command is given on the keyboard, the
communication is stopped.
To reactivate the communication go to [Setup]-[SerialPorts]-[Operator device at] and select the interface ,
e.g. [Builtin] again.
To Next Page
Loading...