Commissioning PR 5610 Installation Manual
94 Sartorius
Possible error message
User tried to select the parameters of e.g. Built-in RS232, which
has been assigned to printer device or operator device (parame-
ters are already fixed).
4.8.3 Software parameters
Basic parameters are defined in the section [Setup]-[Software Parameter].
Select [Software Parameter] with or ; confirm with .
4.8.3.1 Language
The dialogue language for all general menu items found under [Setup] is English. The items under [Setup]-
[Config] depend on the application program and can be changed with the following menu:
Select [English] or [Local Language] (Deutsch) with or ;
confirm with
.
4.8.3.2 Key timeout
Select [1], [2] or [3] sec. with
or ; confirm with .
Defined parameter is the hold time for showing Net or Gross after
respective key was released.
4.8.3.3 Low Battery Check
Select battery check [on], [off] or [1 min]. If [on] or [1 min] is
selected , and the battery is low, the following message appears:
4.8.3.4 Report to
Configuration item for reports generated by an application package (e.g. IBC-Controller). The queue of reports is
limited to a maximum of ten entries. In case the reports could not be sent, the operator is asked whether he
wants to delete the oldest report.
Select the options [none], [communication], [application],
[communic.
& appl.] or [application +Prod.] for the reports
generated by the application program (e.g. IBC-Controller) with
or ; confirm with .
Select [communication] for PR 1740 and [application] for the
local printer.
Select [communic.
& appl] for PR 1740 and a local printer.
Select [application +Prod.] for IEC 61131 Programs which use the
Production Report Table.
To Next Page
Loading...