Hardware Configuration PR 5610 Installation Manual
56 Sartorius
3.4.13 PR 1721/14 DeviceNet interface
The DeviceNet interface PR 1721/14 is an option to be installed in slot 4 of PR5610, see chapter 3.2.2.
Communication protocols and syntax comply with the relevant bus standard.
Connecting method: 50 pole connector, slot 4
Terminal block with 5 screw
terminals
Transmission rate:
DeviceNet 500 kbits/sec
Protocols:
Device-Net slave
Cable: Shielded twisted pair
Cable impedance: 150 Ohm
Dimension (LxWxH): 70 x 86 x 25 mm Potential isolation: Yes
Weight: 65 grs.
Please ensure, that the DIP switches 1- 8 are set to ON
Connection diagram for a master and three slaves in an Interbus-S
For further information please refer to the manuals Fieldbus-Interface PR 1721/1x (hardware) and
Fieldbus PR 1713 with PR 1721/.. (software).