Commissioning PR 5610 Installation Manual
86 Sartorius
4.7.4 xBPI Scale parameters
In menu [Setup]-[Weighingpoints]-[WP X:xBPIScale]-[Setup]-[Config] the scale parameters are set. Before
entering this menu, the protocol (see chapter 4.7.1) and the WP (see chapter 4.7.2) have to be defined and the
communication between the instrument and the Sartorius scale or platform must be in active staus.
Select [Setup].
The PR 5610 is loading the parameters from the Sartorius
scale.
Error message:
No communication with xBPI scale
The scale menu appears, select [Config].
Select [Scale] or [Appl] or [Interf], the list of parameters is
shown in chapter 4.7.5.
If [Appl] was selected, the first parameter is shown,
parameters can be altered as in other menus.
The menu can be left with
Select [YES] for saving the data, [NO] for leaving with data
unchanged.
After selecting [YES] the progress of saving data is shown.
Return to next higher level.
For printing the scale parameters press .
To Next Page
Loading...