Sartorius PR 5610 - PR 1721;12 Interbus Interface

PR 5610 Installation Manual Hardware Configuration
Sartorius 55
3.4.12 PR 1721/12 Interbus interface
The Interbus interface PR 1721/12 is an option to be installed in slot 4 of PR5610, see chapter 3.2.2.
Communication protocols and syntax comply with the relevant bus standard.
Connecting method: 50 pole connector, slot 4
Terminal block with 6 + 7 screw
terminals
Transmission rate:
500 kbits/sec.
Protocols:
Interbus-S slave
Cable: Shielded twisted pair
Cable impedance: 150 Ohm
Dimension (LxWxH): 70 x 86 x 25 mm Potential isolation: Yes
Weight: 65 grs.
Connection diagram for a master and three slaves in an Interbus-S
For further information please refer to the manuals Fieldbus-Interface PR 1721/1x (hardware) and
Fieldbus PR 1713 with PR 1721/.. (software).