Sartorius PR 5610 - PR 1713;13 DIOS Master

PR 5610 Installation Manual Hardware Configuration
Sartorius 45
3.4.7 PR 1713/13 DIOS master
Only 1 card PR 1713/13 can be used. The DIOS card (digital I/O system as a simple Interbus-S master) is the
connecting module for external I/O extension.
Connecting method: 2-row 25-pin connector
Terminal block A with 8 screw
terminals
Number of inputs / outputs:
max. 256 bits
or 16 modules
Dimension (LxWxH): 80 x 68 x 15 mm Potential isolation: Yes, optocoupled
Weight: 33 grs.
The maximum possible number of bits is 256 (sum of max. bits per module) or 16 modules at the remote bus.
Only one Interbus-S master in the system is possible! Interbus-S is intended for process data input and output.
The card has galvanically isolated connections and integrated termination resistors. No jumper 5-9 is fitted
(master). The DIOS card parameters are adjusted via software configuration.
The transfer rate for e.g. 256 bits is approx. 32ms.
The DIOS master offers:
• a bus interface for max. 256 additional dig. I/Os
• automatic detection of connected modules
• connection of PR 1720 as 2
nd
weighing point
Pin allocation of option connectors in the unit (installation see chapter 3.2.1)
Terminal block A Interbus-S A1 A2 A3 A4 A5 A6 A7 A8
lower row DO DI GND
(ext.)
nc nc /DO /DI nc