Annex PR 5610 Installation Manual
158 Sartorius
7 ANNEX
7.1 Spare parts
Description Service code number
MAINBOARD, BOARD 1 (POWER SUPPLY / ANALOG PART / SLOT 1 - 3)
PLEASE OBSERVE BOARD NUMBER / LICENCE
5312 216 98338
DIGITAL BOARD, BOARD 2 (PROCESSOR / SLOT 4) 5312 216 98339
MAINS TRANSFORMER 5312 145 48006
FRONT FOIL KEYPAD Batch-X5 5312 455 98044
FRONT FOIL KEYPAD IBC-X5 5312 455 98045
FRONT FOIL KEYPAD Flow-X5 5312 455 98046
FRONT FOIL KEYPAD Truck-X5 5312 455 98047
DISPLAY BOARD CX 050 5312 131 98011
FRONTPLATE 8 SCREWS (without PCBs) 5312 310 18047
BATTERY LITHIUM 3V CR2354 (ON BOARD 2) 5312 138 18013
FUSE 250 MA delayed 5312 253 28005
CABLE ENTRY GLAND PG 9 5312 505 48013
CABLE ENTRY GLAND PG 13.5 5312 505 48014
CABLE ENTRY GLAND PG 11 5312 505 48015
CONNECTOR, 7 POL / LOADCELL 5312 264 48007
CONNECTOR , 5 POL BUILT-IN SER I/O 5312 264 48008
CONNECTOR , 8 POL - OPTION SLOTS 5312 264 48009
SCREW FOR FRONTPLATE (10 pieces) 5312 502 18009
GASKET FOR FRONTPLATE on request
7.2 Further documents
Depending on the application package (e.g. Batch-X5), the corresponding Operating Manuals are delivered
7.3 Glossary
The following terminology is used in this document:
ADC Analog digital converter, internal ADC (LC signal converter)
CAL-switch Single in line switch for data protection (see chapter 3.2)
COLD start All programs and tables loaded in the RAM are erased
DDE Microsoft communication protocol (Dynamic Data Exchange)
EW protocol The serial communication protocol for SARTORIUS batching systems, version V1/ V2/ V3
Flash Program loading (also parts)
FSD Full scale deflection
GND Ground, common (earth) potential
InBatch Batch Control System of the Wonderware company
Interbus-S A standard communication protocol
ISA S88.01 ISA standard related to Batch Control
PLC Programmable logic controller (German: SPS)
Profibus DP A standard communication protocol
Recipe Recipe (see ISA S88)
SPM Memory area (Scratch Pad Memory) of internal PLC
Warmstart Initialization, all data remain unchanged
To Next Page
Loading...