PR 5610 Installation Manual Commissioning
Sartorius 89
[Interf]
"Communication type :"
"SBI protocol "
"xBPI protocol "
"Baudrate for SBI :"
" 150 baud"
" 300 baud"
" 600 baud"
" 1200 baud"
" 2400 baud"
" 4800 baud"
" 9600 baud"
" 19200 baud"
"Parity for SBI :"
" Mark"
" Space"
" Odd"
" Even"
"Stop bits :"
" 1 stop bit "
" 2 stop bits"
"Handshake :"
"software handshake"
"CTS with 2 chr.pau"
"CTS with 1 chr.pau"
"Data output print :"
"on requ always "
"on requ when stab "
"on requ with store"
"auto "
"auto when stable "
"Auto print :"
"start/stop by ESCP"
"not stoppable "
"Output format :"
"without ID 16 byte"
"with ID 22 byte"
"Data output interval:"
"with each display "
"after 2 updates "
"after 5 updates "
"after 10 updates "
"after 20 updates "
"after 50 updates "
"after 100 updates "
"Parameter change :"
"can be changed "
"cannot be changed "
4.7.6 xBPI Scale setting deadload
In menu [Setup]-[Weighingpoints]-[WP X:xBPIScale]-[Setup]-[Calib] the deadload can be set. For GWT scales
the term
deadload
is used, for Sartorius scales the term
preload
is used.
After selecting [xBPI Scale Setup], the instrument is loading
the parameters from the Sartorius scale.
The scale menu appears, select [Calib].
Select [Deadld].
Unload the scale and select [Set]. The weight display shows
0. The menu returns to [xBPI Scale calibrat.].
Alternatively the stored deadload can be erased:
Unload the scale and select [Delete]. The stored deadload
will be erased. The weight display shows the current
deadload. The menu returns to [xBPI Scale calibrat.]
4.7.7 xBPI Scale error message
Menu appears if an error occurs during calibration. The
error has to be acknowledged.
Depending on the behaviour of the scale the instrument
remains in the calibration (adjustment) level.
To Next Page
Loading...