Sartorius PR 5610 - Sub-Menu Service; Available Memory in PR 5610

Commissioning with Terminal PR 5610 Installation Manual
140 Sartorius
5.7 Sub-menu Service
Mask
Service is called up from the Main-Command-Level by pressing key [S].
PR1713 Rel. 03.12 20.05.2004 09:05
Service Mo 06.May 2002 09:31:51
H Show hardware configuration
M Show available memory
T Test Inputs/Outputs
F Show last fault
B Show Bios version
P Print all configuration data
E Exit
The following menu items are called up by pressing the relevant keys:
• Display of hardware configuration H Show hardware configuration
• Display of available memory M Show available memory
• Test of input and output modules T Test Inputs/Outputs
⇒ If a production is busy, the module test (T) is disabled:
Production is active, testmode is not possible
Hit any key to continue
Press any key to remove this message.
• Hex-Dump of the last "fatal system error" F Show last fault
⇒ The last error is shown, even if a new software has been flashed
• Current Bios version B Show Bios version
• Print out all configuration data. P Print all configuration data
• Leave sub-menu Service E Exit
As no data can be changed, return is direct to the main menu without additional prompts.
5.7.1 Available memory in PR 5610
Calling up mask Show available memory is from sub-menu Service by pressing key [M].
PR1713 Rel.02.00 02.05.2002 09:05
Service Mo 05.July 2004 09:31:51
MEMORY STATISTICS
262144 bytes physical memory bank 1
+ 0
bytes physical memory bank 2
262144 bytes total physical memory
- 156928
bytes used by system
105216 bytes maximum memory available
- 16608
bytes memory in use
88608 bytes free memory
1 blocks
88608 bytes in largest block
Hit any key to continue